A
adl
Active Member
Full Member
- Messages
- 454
- Reaction score
- 66
Thank you all for the responses. I clean the mill every time I mill something,change the burs religiously and only use the re-seller burs. They kind of get expensive paying $50-$60 per bur and only lasting me on average 20 units.a ground wire for the z axis was also inserted inside the mill.i figure my burs are ok since I don't get any chipping .only opened the mill once and I was pleasantly surprised not to see a lot of dust inside.im open to any suggestions and thank you for the input.
I do spindle maintence every time I'm done milling zirconia ,no matter how many units I mill.obviously this issue comes up only with zirconia.i could probably mill wax 24/7 without any problems.when I clean the inside of the mill I use a flat brush and a small shop vac..I have not taken the mill apart besides taken the cover off and cleaning it when I installed the ground wire for the z axis.
I appreciate everyone's help and expertise ,I don't take it for granted.thank you guys
I do spindle maintence every time I'm done milling zirconia ,no matter how many units I mill.obviously this issue comes up only with zirconia.i could probably mill wax 24/7 without any problems.when I clean the inside of the mill I use a flat brush and a small shop vac..I have not taken the mill apart besides taken the cover off and cleaning it when I installed the ground wire for the z axis.
I appreciate everyone's help and expertise ,I don't take it for granted.thank you guys