Yes, I know. Thanks.
You need to know how to do it not me! LOL and I'd show you!
I already know how to make the correct post for my mills.
ex, what are limits of a and b?, how to make tool measurement happen?, how to even make feedrate (that is specific to HAAS!) and if to use inverse time, how to begin and end a program, what workoffset, etc etc......checking for broken tool? How to call up a tool change, coolant M code is normal?? When to cut on/off, etc etc.....LOL
I would just show you faster than you could figure it out for yourself.
I check your work by reading the output from your cam. DUH!!
I hope you can work your own program to just make these necessary adjustements in minutes.
I tell you what is needed.
I am not paying for $25k for that. No thanks!
I just helped do work for you. Why do I pay extra for that!! LOL