rkm rdt
Well-Known Member
Full Member
- Messages
- 21,466
- Reaction score
- 3,288
I use the internal czr stain on ex3 all the time.
indeed magician ^^ , i was wondering what is the blue material ? silicon ? or patty
I use the internal czr stain on ex3 all the time.
I use the internal czr stain on ex3 all the time.
Shalom Edy, as you could see it is a hard niteguard material 3-3/12mm in thickness. This is a great community of talented dental techs.!!! The tab was done on this tool, it is T blue, if you experience difficulty in making tabs with the tool I have more tricks to make easier for you, good luck!!!
Shalom Tayeb ,the dificulty may be not finding this niteguard material here where i live , maybe i will try it with patty.in the picture ur tabs looks lovely , you smooth polish it after it comes out of furnace ? or leave it like that
Beautiful Martin ,love the colors and anatomy !
Lovely i didnot knew u can play with value with internal stain too , i will check those books ty a lot ...what is the difference of drawing on canvas and drawing on paper ? i just watched a yt video and the man is drawing pretty normally to me on canvas .(i wonder if internal stain of the czr can be used on ex3 , i got a full upper bridge now A 3.5 , would love to try some mamelons ,its cervical 3 IS , its written on it Internal stain , not Internal live stain , is it the same ?)
In this specific case:
In first baking a thin layer(over the dentin) of TBlu+ Blue and then over E3.
2nd backing: To0 incisal Tblu prox, LT1 body, incisal edge of the tooth PE1.
Edy, on facebook at this address you can find useful information on NORITAKE
https://www.facebook.com/Noritake.Dental.International?fref=ts