rkm rdt
Well-Known Member
Full Member
- Messages
- 21,446
- Reaction score
- 3,288
All this for a lousy phone pic? What are we here? Fail Army?
All this for a lousy phone pic? What are we here? Fail Army?
Gary Busy tooth library.
What is the strength on that zirconia? Cantilever bridge with high trans zirconia even anterior has never worked for me. I’ve found using 1200mpa designed well with good cutback much stronger than Full contour with high translucent. Case looks great.
no they dont all need.Do all milled bridges need a support bar attached? I have a three unit anterior to mill out today.What length requires a support bar?
Thank you!No they don't all need. I don't think you need for a 3 unit bridge.
I think as a standard I've heard 6+ units will need the support bar. You should stick to this.
I've done 10-11 unit bridges without any support structure that fit perfect. I think it is because of the sintering granulat like the one Zubler or AG sells. It acts as a support.