M
Majormattie
New Member
- Messages
- 4
- Reaction score
- 0
We have occasionally been running into an issue with our MCX5 failing to complete the intaglio milling for some implant cases.
The crowns are pre-designed, so it is just importing the STL into CAM and marking the margin. Occasionally it seems that the mill just stops before completing the intaglio surface of the designs preventing it from properly seating. Ran through everything with support already but was unable to identify anything that would be causing the issue.
Anyone happen to run into a similar issue or have any thoughts/ideas?
Thanks so much!
The crowns are pre-designed, so it is just importing the STL into CAM and marking the margin. Occasionally it seems that the mill just stops before completing the intaglio surface of the designs preventing it from properly seating. Ran through everything with support already but was unable to identify anything that would be causing the issue.
Anyone happen to run into a similar issue or have any thoughts/ideas?
Thanks so much!
