D
dirkkk50
Member
Full Member
- Messages
- 11
- Reaction score
- 3
Today I ordered the Medit Identica Blue 2015, (with the Artex jig and table). The dealer here in the Netherlands did give me the opportunity to work with the scanner for about 2 weeks. And it did exceed my expectations.
The only thing that bothers me are the spec's for the hardware. The demo set was running Exocad with an Intel i5 core and a nVidia geforce 510 4gb and 8gb of memory. That's not enough, because there is a serious lag, it doesn't run smoothly. Especially in combination with my 3d space pilot.
I can find the minimum spec's for Exocad, but I can't find hardware spec's witch will give me a smooth handling in Exocad.
Can somebody give me the optimal hardware setup to run the Medit Identica Blue 2015 running Exocad?
The only thing that bothers me are the spec's for the hardware. The demo set was running Exocad with an Intel i5 core and a nVidia geforce 510 4gb and 8gb of memory. That's not enough, because there is a serious lag, it doesn't run smoothly. Especially in combination with my 3d space pilot.
I can find the minimum spec's for Exocad, but I can't find hardware spec's witch will give me a smooth handling in Exocad.
Can somebody give me the optimal hardware setup to run the Medit Identica Blue 2015 running Exocad?