Just a little modification I did for the gun "holster". I cut it from the one side, smoothed that out, then left a length to bend over to help keep the handle in place and to keep it from rubbing against a sharp edge.
It just makes it a little easier in dropping the handle into the holder, rather then threading it through the opening. You can bend it in a bit to help with a friction fit.
You probably also noticed that the holder can be mounted on either side of the unit, it has the pre drilled screw holes for it. My unit is older, thus white. I think the newer ones are stainless steel.
View attachment 37116 View attachment 37117 View attachment 37118