L
LothamerLab
New Member
Full Member
- Messages
- 5
- Reaction score
- 0
Hello all,
I am trying to figure out the ideal settings for sectioned models in 3Shape Model Builder. So far, my printed dies are either too loose, or too tight and don't go down all the way into the model. I'm using Acukuretta CURO Element Model resin. I've been just setting Die to Model Spacing and Post to Model Spacing to 0.02mm, and all the rest of the values under "Interfaces" to 0. With these settings, the die goes in snugly, but the alignment holes in the model and die don't quite line up, showing that the die isn't down all the way. Does anyone have any suggestions on settings that I could tweak, or values that could be changed to remedy this issue?
Thanks!
I am trying to figure out the ideal settings for sectioned models in 3Shape Model Builder. So far, my printed dies are either too loose, or too tight and don't go down all the way into the model. I'm using Acukuretta CURO Element Model resin. I've been just setting Die to Model Spacing and Post to Model Spacing to 0.02mm, and all the rest of the values under "Interfaces" to 0. With these settings, the die goes in snugly, but the alignment holes in the model and die don't quite line up, showing that the die isn't down all the way. Does anyone have any suggestions on settings that I could tweak, or values that could be changed to remedy this issue?
Thanks!