RileyS
Well-Known Member
Full Member
- Messages
- 2,869
- Reaction score
- 461
How do you do that?With photos and other visual aids, I scan the preop situation model and make my alterations with editing tools in the software to the virtual model..
How do you do that?With photos and other visual aids, I scan the preop situation model and make my alterations with editing tools in the software to the virtual model..
exocadHow do you do that?
Frick!exocad
Here's what the milled wax result is. Came pretty stinkin good! Only adjusted a few spots on one quadrant to get better equilibration.
It's clearly not as defined as hand waxed and I could have spent some time separating teeth better but fed a time saver with a good usable result.
I milled this in bridges. Three upper and three lower.
View attachment 18212 View attachment 18213 View attachment 18214 View attachment 18215 View attachment 18216
I prepped them. Each time I try 3shapes temp module it ends up freezing or doing something stupid.Did you prep the models or use a provisional module?
Thanks. I hope to improve to really darn good soon!That's pretty darn good.
Thanks. I hope to improve to really darn good soon!
Hey, I just heard of this amazing new doohickey that takes pictures of teeth and then you can use a computator to make a crown! I think you may like something like that!since handmade is obviously better,why don't you get a plastic tray and mix some alginate and then ....never mind.
Hey, I just heard of this amazing new doohickey that takes pictures of teeth and then you can use a computator to make a crown! I think you may like something like that!