Only feedback I would give you is to tell us what porcelain you used, the shade, etc.
Yes ofc, sry
I used inline porcelain. Shade was D3.
I did not made a complicated build up, because i had to finish it fast.
Used cervical dentin d2/3 in the cervical and in the interproximal areas and a little bit higher to the canines.
Deep dentin d3 on the incisal edge of the frame to avoid any bleeding here.
Then dentin D3 to whole body and formed mamelons with the dentin only.
OE1 around the incisal edge and a little bit T neutral from incisal to middle third.
A thin coat of OE2 to the middle third and covered everything with TI3 but used TI2 to the transition lines and areas.
For the incisal edge and hallo effect i mixed dentin D3 with TI3 50/50.
The while lines are just external stain and used a little bit of creme to fix the incisal edge where i didn't like it. And a little bit shade stain to the cusp top of the canine.
After glaze i hand polish with pink and white rubbers and diamond paste.
This use of cervical dentin, and hand polish after glaze i got it from you guys, reading this thread, thank you!!