Resize mesh in exocad

[qbawy]

Hi all! As above... can the mesh be resized in exocad? I have some face scans that I load as preop scans, but they come up tiny (like grain of sand) comparing to the jaw scans....
aNY solution to that? maybe some other software I can use to do this? (.obj and .ply files)

THANKS!

 

[CoolHandLuke]

it would seem you arent set up to correctly import obj and ply scans with the correct scale. not all scans were created equal my friend. i'm mostly sure your exocad vendor should be able to handle this, if someone here can't.

 

[qbawy]

it would seem you arent set up to correctly import obj and ply scans with the correct scale. not all scans were created equal my friend. i'm mostly sure your exocad vendor should be able to handle this, if someone here can't.

Hi CHL, I am sorted. It was the scanners output settings. It was exporting in meters, but it should in mm. All is fine now. Thanks!

 

[cadfan]

just a small difference factor 1000