Mike2
Active Member
Full Member
- Messages
- 568
- Reaction score
- 73
I have had a couple hiccups in the past few pucks? I had 1 crown of 20 in last 2 jobs that came out with hole milled through that were not part of the design?? Its seems as though the mill is losing connection with PC for CNC info?? Today I started a full puck and on the third unit it just stopped and paused all while spindle was running and not moving throughX,Y,Z. I had no choice but to abort, but it wouldn't do that either. I shut mill down and subsequently restarted, then I reloaded job and watch and it proceeded so far through all coordinates past where it paused? Any ideas as I am not sure how to resolve, I like consistency, like Ron Popiel.....set it and forget it. Thanks in advance!