Affinity
Well-Known Member
Donator
Full Member
- Messages
- 6,955
- Reaction score
- 1,062
I have millied few crowns so far and results are quite good.
Tero
this is only with the mcxl right?
I have millied few crowns so far and results are quite good.
Tero
"I have millied few crowns so far and results are quite good."
Amazing in MCXL terms = below average
Quite good in MCXL terms = Complete Garbage
Dosent sound too promising!
this is only with the mcxl right?
How much people here know about opening Sironas cam software? Or how to run Sirona millingmachine with another cam? I have see in youtube video where some one is milling zr implant with old cerec3 millingmachine, if I remember right... How this is done?
Where it could be downloaded? And how it was done?In youtube, where Alex milling an Zr implant, He use a CAM soft. NX6 form Siemens. G code.
He open the Cerec motherboard and install your soft. This soft is posible, others too, sure.
Where it could be downloaded? And how it was done?In youtube, where Alex milling an Zr implant, He use a CAM soft. NX6 form Siemens. G code.
He open the Cerec motherboard and install your soft. This soft is posible, others too, sure.