Toothman19
Active Member
Full Member
- Messages
- 693
- Reaction score
- 77
Is there a way in Exocad or any cad software for that matter, to design a zirconia plug that goes into the screw channel?
You could add a cylinder or pin , of the same diameter as your hole, to the lingual surface of your crown .
Then just cut it off and voila !
Jackhammer?So after the plug is inserted ( and cemented I assume) , how does the dr access the screw later?
So after the plug is inserted ( and cemented I assume) , how does the dr access the screw later?
This technique works great:Is there a way in Exocad or any cad software for that matter, to design a zirconia plug that goes into the screw channel?
Its kind of like this...marcus i wonder what it's like to work in your lab environment for a day lol
The doc was curious. We've done a few emax plus for him in the pastSo after the plug is inserted ( and cemented I assume) , how does the dr access the screw later?