A
AKDental
Member
Full Member
- Messages
- 66
- Reaction score
- 1
I am having issues with my crowns not fitting onto the ti base and i am using meditlink software and exocad and i am milling using uniquecam software. I
cannot figure out why this is happening but the crown will almost fit but the last 1mm or so the crown will not go all the way down on to the
tibase abutment which is either an Open Implants or a dess abutment\.
Any thoughts or suggestions are appreciated.
Pls@@!!! I need hellp with this or i might end up spending a lot of $$$ on new CAM software....
cannot figure out why this is happening but the crown will almost fit but the last 1mm or so the crown will not go all the way down on to the
tibase abutment which is either an Open Implants or a dess abutment\.
Any thoughts or suggestions are appreciated.
Pls@@!!! I need hellp with this or i might end up spending a lot of $$$ on new CAM software....