Exocad custom tooth library mesh problem

[rookiee]

Hi!

Tryin to make custom library but problem is that model editor can't "fix" the mesh. And I have no clue what to do, what kind of procedure to go over to make it work. Probably thats why I can create points etc...STLs look ok, closed from bottom...Can anyone give me a sugesstion what to "fix" or do in meshmixer maybe or similar?

 

[ToofMaker]

I can take a look at the mesh if you would like to send it to me

 

[Njaroo]

Hi!

Tryin to make custom library but problem is that model editor can't "fix" the mesh. And I have no clue what to do, what kind of procedure to go over to make it work. Probably thats why I can create points etc...STLs look ok, closed from bottom...Can anyone give me a sugesstion what to "fix" or do in meshmixer maybe or similar?

Hi man i have a same problem but on exocad with custom library, but the mesh is closed and do i need to open it will it work, and if so what program i need to use to open the holes in mesh ??

 

[DigiSculpt Design Center]

 

[Njaroo]

Thank you very much it worked