D
Danparm
Member
- Messages
- 1
- Reaction score
- 0
I'm trying to replace an upper jaw scan/model with a new scan of an existing project.
I printed a denture for try-in, had to move the centerline and I took a sectional pickup impression for a short area in the base, I've rescanned the denture and realigned it as a post-op scan which was fine, moved the centerline but I'd like to replace the existing (peripherally short) model with this new scan which has a pickup impression scan, for the life of me I can't figure it out.
Pulling my hair out.... any help is welcome!!
Thanks.
I printed a denture for try-in, had to move the centerline and I took a sectional pickup impression for a short area in the base, I've rescanned the denture and realigned it as a post-op scan which was fine, moved the centerline but I'd like to replace the existing (peripherally short) model with this new scan which has a pickup impression scan, for the life of me I can't figure it out.
Pulling my hair out.... any help is welcome!!
Thanks.