Z
zellyen
New Member
Full Member
- Messages
- 6
- Reaction score
- 0
Hello all,
I am a complete novice when it comes to milling. I recently decided to volunteer at a university where they own a versamill. They want to get it up and running (as no one utilizes it!). Their milling software is Dentmill. Things are now up and running, however, I am running into a few issues.
When I try to mill PMMA provisionals (off of a scan of the prep),it always comes out loose (overmilled for some reason). Even when I minimize the cement spacer in exocad, it does not appear to help.
For anyone who owns the same hardware/software, is there a setting that I need to play around with? Is there an inherent setting for PMMA material?
Any insight is greatly appreciated.
Thank you
I am a complete novice when it comes to milling. I recently decided to volunteer at a university where they own a versamill. They want to get it up and running (as no one utilizes it!). Their milling software is Dentmill. Things are now up and running, however, I am running into a few issues.
When I try to mill PMMA provisionals (off of a scan of the prep),it always comes out loose (overmilled for some reason). Even when I minimize the cement spacer in exocad, it does not appear to help.
For anyone who owns the same hardware/software, is there a setting that I need to play around with? Is there an inherent setting for PMMA material?
Any insight is greatly appreciated.
Thank you