W
weswideman
Member
Full Member
- Messages
- 13
- Reaction score
- 1
Hi, is anyone using the 3shape splint studio with the 2019 software update? How do you like it?
Hey @weswidemanHi, is anyone using the 3shape splint studio with the 2019 software update? How do you like it?
so even though we have it downloaded (which i saw the argen rep. do on teamviewer),we still can't use it. never the less access it?Hey @weswideman
So the new Splint Studio has not yet been released in the U.S (I'm not sure where you're located). It is still pending FDA approval. But it is going to be a MAJOR improvement over the current splint software. We're hoping for it to be released before the end of the year.
I'm really not sure. Resellers should not be installing non-FDA approved software in the United States. I doubt it will work, but you can try!so even though we have it downloaded (which i saw the argen rep. do on teamviewer),we still can't use it. never the less access it?
I saw him install it, but i have no clue on how to access it. that is if it's even possible. so i'm pretty certain, that it's probably because of the reason you have mentioned above, why we cannot access it.I'm really not sure. Resellers should not be installing non-FDA approved software in the United States. I doubt it will work, but you can try!
Your setup is the same as mine, are you adjusting any of the presets for fit?Splint Studio is a massive improvement from pre-2019.
It works off of Dental Desktop, alongside Designer and has similar UI. We're doing all of our splints in Splint Studio, and printing them with KeySplint resin (the resin isn't FDA cleared either, but available in EU and Canada).