D
drstranger
Member
Full Member
- Messages
- 33
- Reaction score
- 6
Hi,
I have bought a used 2009 Lava ST scanner with a Steinbichler dongle.
From reading the forum, i have understood that i need a special PC that has a usb 2.0 controller card and a firewire card.
I want to run it with exocad, so where do i get the driver from, when i have the Steinbichler dongle?
What other things do I need to get it running?
Does anyone know where I can get the calibration block from?
I have purchased the scanner in Germany and I have to send it to Australia, what measurements have to be taken to send the scanner safely with air freight?
Thanks
I have bought a used 2009 Lava ST scanner with a Steinbichler dongle.
From reading the forum, i have understood that i need a special PC that has a usb 2.0 controller card and a firewire card.
I want to run it with exocad, so where do i get the driver from, when i have the Steinbichler dongle?
What other things do I need to get it running?
Does anyone know where I can get the calibration block from?
I have purchased the scanner in Germany and I have to send it to Australia, what measurements have to be taken to send the scanner safely with air freight?
Thanks