Car 54
Well-Known Member
Donator
Full Member
- Messages
- 8,031
- Reaction score
- 1,122
What I'm doing with the vertex in model builder is no longer adding the cups. I now just flat the male grooves on the cups
that come with the articulator, so I can attache it lower on the back of that flat edge, on both sides, to give me a little more room
for the hinge separation. I don't get a lot of base thickness from the Sirona I/O scans I'm getting, so this helps.
that come with the articulator, so I can attache it lower on the back of that flat edge, on both sides, to give me a little more room
for the hinge separation. I don't get a lot of base thickness from the Sirona I/O scans I'm getting, so this helps.