I struggled a bit with whether or not to offer two cents here but decided, heck why not?
The specs, at least the ones that are actually published, (a bit of a pet peeve of mine) look a bit light to me.
Maybe I am missing something but with only a 300 watt spindle (S1/continuous) and most curious of all: "Collet chuck pneumatically for tools with 3 mm shank diameter and max. 40 mm total length"
I personal would not consider this machine top of the line. Especially when compared to our Versamills.
The choice of components and configuration of this machine is a bit curious to me. One one hand, according to published information I was able find, the mill appears to tick some boxes for frame and guide system.
However a 300 watt sindle and 3mm tooling will significantly limit the performance of any machine tool.
Here this mill appears to be a bit of an engigma. On one hand, a low power spindle such as this would be easy to stall when taking "heavier" cuts but on the other hand a tool with only a 3mm shank would snap pretty easily under a load that a 300 watt spindle could present (especially if cuttting parameters such as rpm, federate,depth of cut, machining strategy, etc. are not optimized).
Also, based not these specs I just don't see it effectively processing CoCr in any form other than presintered.
Just one guys opinion and YMMV...