V
ViorelP
New Member
Full Member
- Messages
- 10
- Reaction score
- 0
Hello everyone.
I have a problem with both D30 and D15 YenaDent machines.
In exocad i have around 3 thickness. But after milling, i receive something around 0.5, 0.6. Also we need extra work to adapt them. Any suggestion why i have this thickness? I calibrate, measure the A table to be perfect horizontal, clean the spindle collet, still same thickness.
Thank you.
I have a problem with both D30 and D15 YenaDent machines.
In exocad i have around 3 thickness. But after milling, i receive something around 0.5, 0.6. Also we need extra work to adapt them. Any suggestion why i have this thickness? I calibrate, measure the A table to be perfect horizontal, clean the spindle collet, still same thickness.
Thank you.