Try this with alginate and plaster

zero_zero

zero_zero

Well-Known Member
Full Member
Beats me...I don't know how to replicate that texture...Dontknow
 
rkm rdt

rkm rdt

Well-Known Member
Full Member
Dr will remove mx wires to add 2 pmma temps to the peg laterals and then reattach the wires.
 
zero_zero

zero_zero

Well-Known Member
Full Member
Design and make those temps with brackets integral...then you rule the world Adore
 
rkm rdt

rkm rdt

Well-Known Member
Full Member
Design and make those temps with brackets integral...then you rule the world Adore
That would be cool for sure. On this case,the dr will just reuse the existing ones .I'll post pics of the temps after.Hope I get some intraoral pics too.
 
PearlZ

PearlZ

Active Member
Full Member
Design and make those temps with brackets integral...then you rule the world Adore
can't be too hard.

1. snip a bracket off and scan it, add to attachment library

2. add to design

the only hard part i foresee is actually making the thing lol

so probably better idea is not to add the bracket but add a m/f connector so one can snap in. perhaps a pair of holes, or dome...

which again wouldnt be too hard, just add this interface to the bracket, use the pinpoint waxup holder and scan it in, ensuring the correct orientation, you should be able to add it as subtractive attachment...

and bingo.
 
rkm rdt

rkm rdt

Well-Known Member
Full Member
or just bond an existing bracket to the temp.
 
Guest Room
Help Users
  • No one is chatting at the moment.
  • Chat Bot:
    Room has been pruned!
    Chat Bot: Room has been pruned!
    Top Bottom