Try this with alginate and plaster

rkm rdt

rkm rdt

Well-Known Member
Full Member
Messages
21,406
Reaction score
3,288
DSC_1000_zpshdpbohbz.jpg
 
zero_zero

zero_zero

Well-Known Member
Full Member
Messages
6,293
Reaction score
1,397
Beats me...I don't know how to replicate that texture...Dontknow
 
rkm rdt

rkm rdt

Well-Known Member
Full Member
Messages
21,406
Reaction score
3,288
Dr will remove mx wires to add 2 pmma temps to the peg laterals and then reattach the wires.
 
zero_zero

zero_zero

Well-Known Member
Full Member
Messages
6,293
Reaction score
1,397
Design and make those temps with brackets integral...then you rule the world Adore
 
rkm rdt

rkm rdt

Well-Known Member
Full Member
Messages
21,406
Reaction score
3,288
Design and make those temps with brackets integral...then you rule the world Adore

That would be cool for sure. On this case,the dr will just reuse the existing ones .I'll post pics of the temps after.Hope I get some intraoral pics too.
 
PearlZ

PearlZ

Active Member
Full Member
Messages
519
Reaction score
104
Design and make those temps with brackets integral...then you rule the world Adore
can't be too hard.

1. snip a bracket off and scan it, add to attachment library

2. add to design

the only hard part i foresee is actually making the thing lol

so probably better idea is not to add the bracket but add a m/f connector so one can snap in. perhaps a pair of holes, or dome...

which again wouldnt be too hard, just add this interface to the bracket, use the pinpoint waxup holder and scan it in, ensuring the correct orientation, you should be able to add it as subtractive attachment...

and bingo.
 
rkm rdt

rkm rdt

Well-Known Member
Full Member
Messages
21,406
Reaction score
3,288
or just bond an existing bracket to the temp.
 

Similar threads

Denturepropgh
Replies
0
Views
335
Denturepropgh
Denturepropgh
mightymouse
Replies
27
Views
1K
Sda36
Sda36
Denturepropgh
Replies
33
Views
2K
nickate
N
Top Bottom