C
CJK Dental Lab
Member
Full Member
- Messages
- 10
- Reaction score
- 0
I have an older Sintra Plus with some issues. Probably 6 years old. S/N: 93110614494.
When I change programming, my zirconia crowns are not fully sintered. But after 2-3 tries on the same program it will return to normal until I switch the program again.
For example I sinter on program 1. This works. Then I sinter on program 2. Pretty much doesn't do anything. Then I try again, and it sinters maybe 60-70%. On the third try it works. But once I go back to program 1 I have to do the whole process again.
Doest anyone have any idea of what is occurring? Is there a repair technician in California, specifically Bay Area? Thank you in advance.
When I change programming, my zirconia crowns are not fully sintered. But after 2-3 tries on the same program it will return to normal until I switch the program again.
For example I sinter on program 1. This works. Then I sinter on program 2. Pretty much doesn't do anything. Then I try again, and it sinters maybe 60-70%. On the third try it works. But once I go back to program 1 I have to do the whole process again.
Doest anyone have any idea of what is occurring? Is there a repair technician in California, specifically Bay Area? Thank you in advance.