K
Kaiser7100
Member
Full Member
- Messages
- 69
- Reaction score
- 11
Bottom load I'm dry milling. Nabertherm telling me to replace elements after 2000 hrs. Does that sound correct?Your Lht...is it the discontinued front load...
View attachment 29032
Or the newer bottom load?
View attachment 29034
Any chance you can snap a close up pic of your elements?
Will try I pulled it out and some black debris but can that throw temps or make everything come out whiter?We had same problem. It started after one year of using furnace. Sulphur powder build up in chimney. When furnace closes the sulphur drops into furnace causing contamination of the zirconia. Removing chimney on top of furnace and steam clean works for us. Just steam clean once a month Run cleaning cycle with some leftover zirconia.
Sent from my iPhone using Tapatalk
Please post some pics. Your sinter oven has a chimney? Like a vent? Its not a sealed chamber?Will try I pulled it out and some black debris but can that throw temps or make everything come out whiter?
I changed to dekama beads from Jensen cause I noticed little yellowing few weeks agoDid you recently changed sintering tray or beads?
I had a batch come out like this once due to new sintering tray+beads Stopped using it right away'
Although I have a feeling it was most likely because I used it with a lid
No you can pull it out like 8 inches long. I'd snap pic but I just put everything back togetherPlease post some pics. Your sinter oven has a chimney? Like a vent? Its not a sealed chamber?