Major margin chipping, 15 cases due this week, R.I.P.

HygienicBee

HygienicBee

Member
Full Member
This may seem obvious to some, but have you checked the burs, spindle chuck, and re-calibrated?
 
sidesh0wb0b

sidesh0wb0b

Well-Known Member
Donator
Full Member
try a new tool. back to basics....grab the carbides, brand new tools. calibrate. do a test crown.
if it works, try new diamond tools. looks to me like the 2mm or 1mm is being a bit aggressive. swap em out!
 
cadfan

cadfan

Well-Known Member
Full Member
try same file in wax same problems ?? if not burs or strategie vs strategie cad config mistake
 
KentPWalton

KentPWalton

Well-Known Member
Full Member
What they said, but also clean your collet. You should have a preventative maintenance scheduled for every machine you have. Those collets should be cleaned and re-greased every week.
 
  • Like
Reactions: JMN
sidesh0wb0b

sidesh0wb0b

Well-Known Member
Donator
Full Member
What they said, but also clean your collet. You should have a preventative maintenance scheduled for every machine you have. Those collets should be cleaned and re-greased every week.
every week being subjective to how much milling youre doing. lol
kent is used to these giants churning out 30000 units a month! Laugh
 
KentPWalton

KentPWalton

Well-Known Member
Full Member
Haha...nope. Better safe than sorry on a piece of equipment don't you agree? Do you want to have to pay for another machine if the company asks you if you followed their recommended PM schedule? You must be doing better than you're leading on if you can afford that! ;)
 
Guest Room
Help Users
  • No one is chatting at the moment.
  • Chat Bot:
    Room has been pruned!
    Chat Bot: Room has been pruned!
    Top Bottom