Jaemin Lee
Member
Full Member
- Messages
- 61
- Reaction score
- 22
Hello.
It's been tough days to decide the gears around CAD/CAM nowadays.
But after I've found out this place, now it is more easy to decide things.
I decide to buy DWX-50 for dry milling machine, and now I have to pick zir sintering furnace.
My DT says Ivoclar is very reliable in every aspect, so I prefer to go for Ivoclar Programat S1.
However, I couldn't find any thereads about S1 here.
On the other hand, I could easily find recommendations for Mihm Vogt.
Is there anyone who's experienced both S1 and HT-S Speed?
And Mihm Vogt dealer is keep on saying that the max temerature of S1 is only 1530C and it can be a problem if I want to use the new HT zir materials.
Is it correct?
Because, all the zir materials that I've searched required only 1450C.
I'll be expecting replies from U, thank you.
It's been tough days to decide the gears around CAD/CAM nowadays.
But after I've found out this place, now it is more easy to decide things.
I decide to buy DWX-50 for dry milling machine, and now I have to pick zir sintering furnace.
My DT says Ivoclar is very reliable in every aspect, so I prefer to go for Ivoclar Programat S1.
However, I couldn't find any thereads about S1 here.
On the other hand, I could easily find recommendations for Mihm Vogt.
Is there anyone who's experienced both S1 and HT-S Speed?
And Mihm Vogt dealer is keep on saying that the max temerature of S1 is only 1530C and it can be a problem if I want to use the new HT zir materials.
Is it correct?
Because, all the zir materials that I've searched required only 1450C.
I'll be expecting replies from U, thank you.