Not that I've seen. I wouldn't leave prints on the plate over, like, a long weekend, but we leave a final job on the plate overnight 5 days a week and it hasn't been an issue for us so far.
Indications claims no more than 8 hrs on the plate, but i've been more than 12 with no trouble. Anyway i bet that any lab in the whole world is more than 8 hrs empty of employers
From the manufacturers IFU: Resin coated parts should be cleaned with Isopropanol (at least 97% purity) within approximately 8 hours from the completion of the print.
I go overnight but cure them ASAP. I once let one sit for a few days and there was some distortion. It was a vertical print at an angle and I guess there was some sagging.
I've seen like the Clear V4 on Form2 causing problems after 3+days ( over weekend is fine usually still),especially not curing correctly then / remaining sticky cause it seems the liquid resin gets concentrated on the lower hanging parts then )