P
Prosthodontics
New Member
Full Member
- Messages
- 26
- Reaction score
- 2
Hi all,
For a number of reasons, we are likely going down the industrial scanner (non-dental) route. We are prepared that integration with exocad is non-existent and we are prepared to do a lot of manual inputting.
It has been brought to my attention that copying scanning of wax-ups may not be as accurate? Why is that and how to overcome it?
Will the virtual articulator and articulator and facebow scanning capability of exocad be preserved with the use of an industrial scanner?
I appreciate all the help I can get. It is a lot harder to go the industrial route!
Cheerio.
For a number of reasons, we are likely going down the industrial scanner (non-dental) route. We are prepared that integration with exocad is non-existent and we are prepared to do a lot of manual inputting.
It has been brought to my attention that copying scanning of wax-ups may not be as accurate? Why is that and how to overcome it?
Will the virtual articulator and articulator and facebow scanning capability of exocad be preserved with the use of an industrial scanner?
I appreciate all the help I can get. It is a lot harder to go the industrial route!
Cheerio.