Exocad Users, Stand Up and Share Tips

[Ryan]

What version of exocad are you using? (Engine build)

5164

 

[2thm8kr]

Are you trying to reduce the whole frame or just the facials?

 

[bigbrush]

If you want to reduce facial do it like this.

 

[Ryan]

Trying to reduce the whole frame except the part that is in contact with the tissue. The reduced part will then be layered. Big Brush I will try your example thanks.

 

[2thm8kr]

Trying to reduce the whole frame except the part that is in contact with the tissue. The reduced part will then be layered. Big Brush I will try your example thanks.

Use this function and mark the area you want to stay in contact with the gingiva.

 

[rkm rdt]

shrinkage? we don't have that problem

 

[zero_zero]

shrinkage? we don't have that problem

Too small already ?

 

[rkm rdt]

Too small already ?

click next to shrink

 

[Ryan]

Thank you both for the help!

I do understand how to use the reduce tool. The main problem was margin marking and adaptation of the Wax up to the bar. I have determined that Exocad is having a hard time adapting with the way my bar is designed and where I need to place my margin. This particular case is a test case, so not such a big deal, I will redesign my bar to eliminate the problem areas and give it another shot.
I have included a pic so you can see

Again, thanks for taking the time.

Ryan

 

[2thm8kr]

Thank you both for the help!

I do understand how to use the reduce tool. The main problem was margin marking and adaptation of the Wax up to the bar. I have determined that Exocad is having a hard time adapting with the way my bar is designed and where I need to place my margin. This particular case is a test case, so not such a big deal, I will redesign my bar to eliminate the problem areas and give it another shot.
I have included a pic so you can see

Again, thanks for taking the time.

Ryan

Ryan, if you want to send me the project file I will give it a try when I have a little extra time.

 

[Ryan]

PM me your info....

 

[eyeloveteeth]

been scanning with D2k and uploading into Exocad. awesome sauce.

 

[French Cadman]

Blue you don't reduce, yellow you reduce , capito ? bien compris ? understood ?

 

[Doug4DAL]

I had a screw retained bridge , 4 units , bone loss , pink tissue , you all know. Pulled in a nice full arch scan , selected as a wax-up , positioned , trimmed , adapted , light contour , set cut back , done.

Took longer to type this on my phone than to do the case.

 

[Profesional Dreamer]

Blue you don't reduce, yellow you reduce , capito ? bien compris ? understood ?

What kind of material and what implant system?

 

[French Cadman]

Zr on 3I implant !

 

[lucky54]

Zr on 3I implant !

Und wie sieht das fertig aus????????????

 

[French Cadman]

Bitte ?

 

[lucky54]

Bitte ?

The finished Work.

 

[Andrea Regio]

Thank you both for the help!

I do understand how to use the reduce tool. The main problem was margin marking and adaptation of the Wax up to the bar...

Ryan

Hi, I'm having problems to adapt a waxup over a bar, like mesh intersections in the inner part where fits the bar. I've tried with all exocad software versions, but I can't find a solution and I suppose that I'm missing something in order module or some configuration string in xml files... Can you please give me an hint? Thank you!