millennium
Active Member
Donator
Full Member
- Messages
- 897
- Reaction score
- 78
Good morning everyone.
I have a case with #13 and #19 preps that oppose one another. Dr. took two impressions and one prep is not clear in each so I had to pour both and have two coupling models.
Short of waxing lets say # 13 and scanning that wax up to design # 19 what is the best way to design both units (FCZs) in Exocad.
Thanks in advance.
I have a case with #13 and #19 preps that oppose one another. Dr. took two impressions and one prep is not clear in each so I had to pour both and have two coupling models.
Short of waxing lets say # 13 and scanning that wax up to design # 19 what is the best way to design both units (FCZs) in Exocad.
Thanks in advance.