K
Kamal
New Member
- Messages
- 1
- Reaction score
- 0
Roland dwx50 spindle over heat after changing bearing
And a part that came out of a new bag isn't always a good part.Usually, if something goes wrong after you did something, it's the thing you did that is to blame. Perhaps something wasn't put back together properly? I would re-do the process checking for anything unusual.
It is only a small 100w motor and a very thin belt... I don't remember having a tensioner eitherCan’t remember for sure but if it is a belt and pulley system, the alignment and belt tension is extremely important. If not correct, these can cause havoc on the bearings and cause heat related problems.
Can you spin the motor freely by hand with no noise?It is only a small 100w motor and a very thin belt... I don't remember having a tensioner either
That's for the OP to answer...Can you spin the motor freely by hand with no noise?
Does it overheat without a load?
That's for the OP to answer...
I spoke to Toland about the same issue 2 weeks ago and they told me they do not sell the bearings separately. I am wondering where did you get them? Were they originals? And yes they said it needs to be greases with the same material that comes with the spindle. Looks like Vaseline.Roland dwx50 spindle over heat after changing bearing
Where you able to fix the problem? I am having the same problemRoland dwx50 spindle over heat after changing bearing
Hello. Can you help me with how to disassemble the spindle of DWX50 to change the bearing?Roland dwx50 spindle over heat after changing bearing
Read here ...Hello. Can you help me with how to disassemble the spindle of DWX50 to change the bearing?
I would appreciate it if you could help me with how to do it since you have experience.
Hello.Hold the spindle in a vise. Loosen the end cap with an adjustable wrench. Tap the collet lightly to release the contents. After that, disassemble it, put in a new bearing, and reassemble it in the same direction as when you removed it.
If you do it yourself, you should buy a new spindle and try again. Also, if you are not confident, you can take it to a machine shop and they will do it for you at a reasonable price.