C
choice
New Member
- Messages
- 4
- Reaction score
- 0
First of all, i wasn't too sure in which forum category this belonged, so i chose this one.
i'll keep this short and simple. 3 years ago i purchased the Sirona inLab Cerec MXCL, and needless to say, there have been many of heartache and headache that has come along with it in the past 3 years as well. It has served it's purpose, and now it's time to move on to big and better things. i'm looking for a new system and here are some requirements i'd like. any suggestions would be helpful.
i'll keep this short and simple. 3 years ago i purchased the Sirona inLab Cerec MXCL, and needless to say, there have been many of heartache and headache that has come along with it in the past 3 years as well. It has served it's purpose, and now it's time to move on to big and better things. i'm looking for a new system and here are some requirements i'd like. any suggestions would be helpful.
- An open system. (Truly open.) I'd like to mix and match my scanner and/or milling unit and i'd like for them to work together seamlessly.
- I'd like to also use this scanner to scan removables as well. I'd like to eventually scan for metal partials and send the files to have printed out in wax/plastic.
- I would like for the new milling unit to be able to mill metal. I'm trying to eliminate waxing inside the lab and i would like to mill directly to metal rather than milling in wax, spruing, investing, casting, de-vesting, etc....