B
Boozy woozy
Member
Full Member
- Messages
- 70
- Reaction score
- 3
Hi worknc experts .. I have a little problem with worknc.. I'm rather new to the software and I'm trying hard to solve this issue but to no real success. I don't know , I was hoping perhaps someone could help me on this .
My problem is milling undercuts from the intaglio surface of the Crown .. I can't seem to activate the fifth axis on the dwx51 d during the remachining stage .. I don't see see the mill flutter around for fine milling .. it just kind of positions the disc at an angle and Mills out what its been told .. the fits are not that great ..
How can I solve this problem , how do I redfine the insertion axis or cavity direction and activate fine milling .. any help would be greatly appreciated .. thank you for listening .
My problem is milling undercuts from the intaglio surface of the Crown .. I can't seem to activate the fifth axis on the dwx51 d during the remachining stage .. I don't see see the mill flutter around for fine milling .. it just kind of positions the disc at an angle and Mills out what its been told .. the fits are not that great ..
How can I solve this problem , how do I redfine the insertion axis or cavity direction and activate fine milling .. any help would be greatly appreciated .. thank you for listening .
