M
mst silva
New Member
Full Member
- Messages
- 11
- Reaction score
- 0
View attachment 16106
The Strategie is complete wrong you see the double slash at the left side in the cam this comands are not executed . Ill think its an abutment or implant strategie with wrong curves and wrong mill comands . Abutment and Implant strategies fill holes sometimes during the process to get better surface.First the surface is milled after that the holes where milled but for each of them are curves in the automatic and although speciall mill operations for example xy or pocket or restmaterial an so on. If you whant to play a bit just change at the same point of the strat only the operation ill think there are 9 or ten and always different things happened although deepened on the curves the curves you see are only from your object and operation 0 degrees or 180 degrees makes another difference.Use a normal Fullzi and maybe less z for better surface and kick out 0.6 and 0.3 from occklusal side.
Take care if you find the command hole side 0 or 180
thank for reply to me again ...
i think my designing is a wrong or wrong mill commands...can you send your designing telescopic crown cad file and cam file...i think i can understand what is the wrong in my designing and what is the wrong in mill command...or can you tel me step by step how can designing and how cam mill telescope crown.....
I do as a mill command-
new job-/ /import a model /type object-telescope offset 2.50/scale 1.254/bounding box optimizer NO/maximum tooth thickness 10.55/.import matching parameters/crown 2bridge-crown -zr-dwx50-roland.cfg/high quality/import raw curves -D98-zr14-ZG-12-0009(My disk register no)and automatic positioning to disk and start mil........
i think my import matching parameaters is wrong.....
your advise is weary helpfully ....
thanks...
silva