T
TomsTeeth
New Member
- Messages
- 4
- Reaction score
- 0
Hi Everyone,
A while back I asked for some advice on whither to get a Dekema or Ivoclar pressing furnace.
I went for the Dekema 644 and love it.
Some of you mentioned that the standard pressing programs that Dekema supply can be a little buggy.
For the most-part it has been good but I have one crown right now that I am remaking for the third time because it didn't press to the end of the crown.
I am going to retry with a longer pressing time and hopefully it makes it all the way through this time (previously set to auto, change to 3min)
Some of you mentioned that you used modified pressing programs, would you mind letting me in on it?
Thanks in advance
A while back I asked for some advice on whither to get a Dekema or Ivoclar pressing furnace.
I went for the Dekema 644 and love it.
Some of you mentioned that the standard pressing programs that Dekema supply can be a little buggy.
For the most-part it has been good but I have one crown right now that I am remaking for the third time because it didn't press to the end of the crown.
I am going to retry with a longer pressing time and hopefully it makes it all the way through this time (previously set to auto, change to 3min)
Some of you mentioned that you used modified pressing programs, would you mind letting me in on it?
Thanks in advance
