DWX-52D Automatic correction not yet finished

[davisdental]

I calibrated my mill and now it gives me error 103B-0000 "Automatic correction not yet finished". When the calibration is complete it says "correction complete" and gives me an OK button to click. When I try to mill, it glows red and gives me this error code. I have done the auto correction several times and gotten the same results. I am waiting on Roland Support to call back, but thought I'd try here and see if I had any luck.

Thanks

 

[Beldent Inc.]

Not sure if this helps ; (updating the firmware to same version)

0000

DGSHAPE DWX-52DCi Manual Online: 0000'' the automatic correction is not yet finished, 0000'' Milling Data Error. The Milling Bur Cannot Reach The Milling Position. Situation/Error Cause • Automatic Correction Has Not Been Performed. • Automatic Correction Was Cancelled Before It Could...

www.manualslib.com

 

[davisdental]

I went to the DG Roland website and downloaded the firmware, drivers and updated the VPanel. Updating the VPanel is what fixed my problem. Thanks for your suggestion.

 

[rookiee]

Happened to me once, I restarted calibration and it was ok...