N
NickB
Member
Full Member
- Messages
- 74
- Reaction score
- 10
Hey all,
Wanted to know if anyone here has yet to replace their spindle in the DWX-50 Roland milling machine. I know the manual says the spindle has roughly 2000 hours of operating time before it should be replaced. Ours is at 1700 or so and we're preparing to buy a new spindle to have on hand once this one goes kaput.
Anyone done this yourself? Is it difficult to replace? Thanks so much
Nick
Wanted to know if anyone here has yet to replace their spindle in the DWX-50 Roland milling machine. I know the manual says the spindle has roughly 2000 hours of operating time before it should be replaced. Ours is at 1700 or so and we're preparing to buy a new spindle to have on hand once this one goes kaput.
Anyone done this yourself? Is it difficult to replace? Thanks so much
Nick