3Shape Unsectioned model bug while scanning

[GoldRunner]

I seem to have encountered a bug while trying to section a model while scanning. I'm able to 'mark the splines' on one or two prepped teeth before it bugs out and doesn't allow me to select any more. There is also some sort of graphical glitch that goes along with it http://imgur.com/so72L20 (extruded look at the bottom of the model). What we're trying to do is make a temporary. If anyone can help that'd be amazing cause this has me stumped.

 

[BDDS]

I seem to have encountered a bug while trying to section a model while scanning. I'm able to 'mark the splines' on one or two prepped teeth before it bugs out and doesn't allow me to select any more. There is also some sort of graphical glitch that goes along with it http://imgur.com/so72L20 (extruded look at the bottom of the model). What we're trying to do is make a temporary. If anyone can help that'd be amazing cause this has me stumped.

Hard to say without looking at it, but whenever I helped anyone in the past we had to make sure all the lines weren't crossed. The spline lines I mean. Have you checked that? None of them can overlap. I dunno, without seeing it first hand that's the first thing I'd check.

 

[JohnWilson]

Pretty nice preps

 

[griffmar79]

I seem to have encountered a bug while trying to section a model while scanning. I'm able to 'mark the splines' on one or two prepped teeth before it bugs out and doesn't allow me to select any more. There is also some sort of graphical glitch that goes along with it http://imgur.com/so72L20 (extruded look at the bottom of the model). What we're trying to do is make a temporary. If anyone can help that'd be amazing cause this has me stumped.

Try changing it to crowns rather than temps in the order form

 

[Ryan Gottlieb]

I have seen this several times as well. Just undo the last sectioning and redo it but play with the spline location. Make sure it does not land close to a hole in the scan or the edge of the model. It can be very frustrating. Good luck

 

[BDDS]

Try changing it to crowns rather than temps in the order form

I went right to the temp answer rather than answering from the pic ... totally right, no need to use the temp function.