N
NJ Lab
New Member
Full Member
- Messages
- 8
- Reaction score
- 1
We sold our lab just a few weeks ago and the new owners did not want our scanner, exocad and software as they have two of the exact same one.
We just purchased an Open Technologies 3D scanner, Excad and workstation with Crown and Bridge and Implant modules.
This set up is 21k brand new, ours was purchased in March of 2016.
We are asking 14,000, make an offer, this is like getting a new car with 1500 miles on it, for substantially less than the one with 25 miles on it. Argen stated they would continue to support and service this scanner and equipment.
Reach out to me on this board or you can email [email protected] or call, Dennis at 914-426-2626
We just purchased an Open Technologies 3D scanner, Excad and workstation with Crown and Bridge and Implant modules.
This set up is 21k brand new, ours was purchased in March of 2016.
We are asking 14,000, make an offer, this is like getting a new car with 1500 miles on it, for substantially less than the one with 25 miles on it. Argen stated they would continue to support and service this scanner and equipment.
Reach out to me on this board or you can email [email protected] or call, Dennis at 914-426-2626