Affinity
Well-Known Member
Donator
Full Member
- Messages
- 6,948
- Reaction score
- 1,062
What alloy and abutments are you using andrew?
Nice work, could explain further your steps and procedure? ThanksI do an average of 5 a day
money
cast on Thursday, fished out my Friday
mostly Straumann and Nobel, but seeing a rise in Zimmer, Bio3i, and Astra EV
these are by far our best Doctors that go PFM as their preference for implant work
we usually use like-on-like with few exceptionsWhat alloy and abutments are you using andrew?
Nice work, could explain further your steps and procedure? Thanks
Nice work Andrew, do you not do Zirconia? Its superior in so many ways and puts way more cash in your pocket rather than the expensive UCLA implant peeps
a titanium crown over a modified snappy.. case was a pita
but Axis milling did a nice job on it...
milled it twice in acrylic to get the fit dialed in.. then sent it to Axis
just thought i'd throw it in
I hate when they adjust those in the mouth, although it's not too big a deal if they then use the correct impression technique and you use the analog made for them.This is a Straumann tissue level solid abutment not a snappy
This is a Straumann tissue level solid abutment not a snappy
yea, I had to make a reduction coping to reduce the analog.. would have been much easier with just a stone modelI hate when they adjust those in the mouth, although it's not too big a deal if they then use the correct impression technique and you use the analog made for them.
.....but they usually don't.