Brett Hansen CDT
Well-Known Member
Full Member
- Messages
- 1,683
- Reaction score
- 102
We are starting to do more of these ASC cases on anterior implant crowns and bridges. I am having issues designing these cases so they don't break or chip in the mill The only reliable way I have found to design these cases is to make the screw channel not go through the entire restoration. I also don't have a good way to design the angled screw channel properly. Right now, i just set the case up so I am looking striaght down into the screw channel and then I just estimate ho much of an angle to tilt the Restoration before I put the hole in it. My mill is a Zenotec Mini and I have the basic milling software.