sndmn2
Well-Known Member
Full Member
- Messages
- 1,026
- Reaction score
- 166
For you guys milling your own Emax. What kind of thickness are you able to mill to without breakage ? Thanks
JMN
Christian Member
Full Member
- Messages
- 12,205
- Reaction score
- 1,884
Isn't there a minimum that 'You Shall Not Pass'?
PRO ARTS DL
Active Member
Full Member
- Messages
- 240
- Reaction score
- 59
I would follow Ivoclar's recommendations.
Just today... a friend... ahem... milled an e.max crown that was thinner than recommended. It fractured when trimming the connector. So yeah, lesson learned.
Just today... a friend... ahem... milled an e.max crown that was thinner than recommended. It fractured when trimming the connector. So yeah, lesson learned.
CoolHandLuke
Idiot
Full Member
- Messages
- 10,095
- Solutions
- 1
- Reaction score
- 1,411
on my planmill, with the ideal conditions, i've gotten away with .5mm
sndmn2
Well-Known Member
Full Member
- Messages
- 1,026
- Reaction score
- 166
Correct me if I'm but I think Ivo. asks for 1mm. That being said if I was restricted to no less than 1mm. my I would be able to mill about one out of ten. I didn't know if Ivo. was just playing safe with the 1mm. guideline or if its gospel .If milled thicker than actual crown clearance allows are you then adj. after crystallization ? .
