M
MTDentalTech
New Member
Full Member
- Messages
- 10
- Reaction score
- 4
Hey, has anyone had an issue with sharing any zz stl files to a third party software. I have been having an issue where on my full arch bridges of zir/PMMA they have at least one implant location where the angle is wrong on the bridge. I have had zz support thoroughly look through the software and scanner and i have had my hyperdent looked at to make sure there is no issue. And it happens no matter if i scan in the ti base vs if i scan in the scan marker. I re scanned in a milled bridge and the screw whole is clearly a different angle on one of the cases from what i designed. The case, other than the angle, milled clean and the bite checks out it is just that the angle is wrong. Its happening on 9/10 cases. Any suggestions would be appreciated.