Edy
Active Member
Full Member
- Messages
- 550
- Reaction score
- 6
Hello , i am new here , this is my first thread here , i am Edy from israel , i just bought programat p500 G2 , and i have few questions if i may , i am a starting dental technician , and i can say i am blessed to have been given this profession , my first question is about the pump which came with the furnace , its the small one -Vacuum Pump VP3 easy- , after i put the firing chart for ceramco3 , furnace start the firing program and when it reaches that it must start the vacuum - V1- stage , the pump start to work , this is the weird part , the pump never stops until the firing program reaches -V2- stage ( vacuum ends) , is this normal ? why i ask this , on my old furnace ELITE 600 , the pump starts vacuum and after it reaches the point that the vacuum is ok , the pump stops working , and the vacuum its released few minutes later by the furnace , the programt furnace its not , the pump its still working until the hole time reaches -V2- ....
My other question is about ceramco3 firing chart , is anyone using here ceramco3 porcelain ? if yes , could you give me dentine 1st and 2nd firing program charts u are using ? and for the natural glaze too , and if you have the charts for the ceramco3 zirconia porcelain same , dentine 1st and 2nd charts + glaze too
Thanks in advance
Edy
My other question is about ceramco3 firing chart , is anyone using here ceramco3 porcelain ? if yes , could you give me dentine 1st and 2nd firing program charts u are using ? and for the natural glaze too , and if you have the charts for the ceramco3 zirconia porcelain same , dentine 1st and 2nd charts + glaze too
Thanks in advance
Edy