PDC
Well-Known Member
Full Member
- Messages
- 997
- Reaction score
- 232
So as I was programming my new Multimat NTX, I find out that the vacuum runs through the entire cycle. On my old Ney QEX it would cut off after it reached the set parameters. It wouldn't be so bad if I still had that old Ney Super Vac pump because it was super quiet. Not so with the newer pumps.
For those of you who have the newer models of porcelain furnaces, does your pump run continuously during a program cycle? I'm just curious which furnace manufacturers, if any, have the "cut off" feature on them.
For those of you who have the newer models of porcelain furnaces, does your pump run continuously during a program cycle? I'm just curious which furnace manufacturers, if any, have the "cut off" feature on them.