Finish tools

[Vazone]

Question about last tool for different cases and materials
In sum3d Standart finish tool for titanium is 2 mm, when 1 mm needed? Who use it?
Same question for zirconium last one?
I mean for copings, I understand that for full crowns smaller=better

 

[NDLMilling]

On titanium, I'm running 2mm rough, a second 2mm semi finishing, then a 1mm for final internal finishing. you need the 1mm for detail on the inside of the crown/coping.. if you finish internal with 2mm, I doubt any of your crowns will fit..

For zirconia, 2mm rough, 1mm finish. And on crowns, I'll use a .6mm tool on the occ. to reproduce as much detail as possible.