S
shong43826
Member
Full Member
- Messages
- 15
- Reaction score
- 0
I was milling a PMMA and the bur got stuck and the milling stop with red led light on. Usually, if I get the red light, I can restart the mill and its ok but its keep giving the red light with the following error code:
"emergency stop 101b-0000 the chucking motor control circuit experienced excessive current"
Has anyone experienced this and if so how can I get this issue fixed?
Thank you
"emergency stop 101b-0000 the chucking motor control circuit experienced excessive current"
Has anyone experienced this and if so how can I get this issue fixed?
Thank you